I have a multicam source sequence that was created with the Switch Audio option.
2 Cameras plus external audio.
Since the external audio wave file had six channels, the multicam sequence is now setup as Multichannel mapped to 6 Mono.
I'm trying to add in footage from a third camera to the existing multicam. The card was not dumped at the time of the shoot along with the others so we didn't get the footage until a few weeks later.
I'm doing this by adding a video track, and another multichannel 6 output track on V4 and A4 respectively and dropping in the new camera.
I'm leaving V3 empty, since that is associated with external audio track.
In the multicam mode in the program monitor, I can see all 4 angles and switch between them and hear the audio following video, yay!
However in the time now I don't have waveforms for any of the camera displayed. Whereas before I added the extra camera, I could see waveforms.
Anyway to fix this? Should I not be trying to add in a new camera angle to an existing multicam?
Also, just tried this with another multicam that was created using the Camera 1 option and same issue. Waveforms are gone now.
I have tried Rendering Audio as well, and no luck.